OUTLINE
The following brake control functions are provided depending on the model: Anti-lock Brake System (ABS), Electronic Brake force Distribution (EBD), brake assist, Traction Control (TRC), Vehicle Stability Control (VSC), Auto limited slip differential (AUTO LSD), trailer sway control, and hill-start assist control.
The skid control ECU processes signals from sensors and performs brake control.
An emergency brake signal system is used. This system reduces the danger of rear-end collisions by automatically flashing the hazard warning lights during emergency braking to warn vehicles to the rear.
A secondary collision brake system is provided depending on the models. This system lessens damage from a secondary collision by controlling the automatic brakes and stop light illumination after a collision occurs.
PRECAUTION
ABS
The ABS system cannot increase the performance limit of the tires. Always drive safely and be aware of the vehicle speed and distance to other vehicles.
Any non-standard components such as non-standard tires that are installed may have a negative effect on the ABS function.
When braking using ABS, the braking distance may be longer than models without ABS in the following conditions:
When driving on a dirt road or a road covered with fresh snow
When using tire chains
When driving over a joint in the road surface
When driving on a rough road such as an unpaved or stone-paved road
Brake Assist
Brake assist cannot increase the performance limit of the fundamental brake system. Always drive safely and be aware of the vehicle speed and distance to other vehicles.
TRC, VSC
The TRC and VSC systems ensure traction and vehicle stability. Do not disable the TRC and VSC functions unless necessary.
The TRC and VSC systems cannot increase the performance limit of the tires. Always drive the vehicle carefully in conditions in which drive wheel traction or vehicle stability may be lost.
Hill-start Assist Control
Hill-start assist control is not intended to keep the vehicle stationary on a hill for a prolonged period. As hill-start assist control only prevents the vehicle from rolling backwards for 2 seconds after the brake pedal is released, perform start-off within this period.
When hill-start assist control is operating and the ignition switch is turned off, hill-start assist control will be canceled without warning.
Hill-start assist control prevents the vehicle from rolling backwards by controlling the brake force to the 4 wheels. However, the vehicle may not remain stationary when on an extremely steep slope or a low friction surface such as ice.
Ignition Switch Expressions
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section:
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
| Ignition Switch Off | LOCK | Off (Lock) |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | On (Start) |