The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the mobilephone battery removal/installation are shown below.
1. PRECAUTION
86740
2.REMOVE TELEPHONE TRANSCEIVER ASSEMBLY
86725
3.REMOVE MOBILEPHONE BATTERY
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Remove the 2 screws.
Remove the 2 screws together with the battery cover.
Detach the claw and guide and remove the battery cover as shown in the illustration.
Disconnect the connector and remove the mobilephone battery as shown in the illustration.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |