Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM
RM35X0E _56 Audio / Visual / Telematics _078379 NAVIGATION / MULTI INFO DISPLAY _0380999 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Touch Panel Switch does not Function  


CAUTION / NOTICE / HINT

NOTICE:

When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:

·

A communication malfunction DTC may be stored.

·

The radio and display receiver assembly may not operate normally.



HINT:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION


PROCEDURE

1.CHECK MULTI-DISPLAY
a.

Check if there is any foreign matter caught between the display and exterior frame of the multi-display.

OK:

No foreign matter is caught between the display and exterior frame of the multi-display.


HINT:
·

If there is foreign matter between the display and exterior frame of the multi-display, the touch panel will remain pressed, preventing touch switch operation.

·

Turn the ignition switch to ACC or ON with your hand touching the operating section, non-response may occur.




Result:
Proceed to
OK
NG



OK

2.CHECK TOUCH PANEL

NG

REMOVE FOREIGN MATTER

2.CHECK TOUCH PANEL
a.

Check for foreign matter on the display.

OK:

The display is clean.



Result:
Proceed to
OK
NG



OK

3.CHECK TOUCH SWITCH (OPERATION CHECK)

NG

CLEAN DISPLAY AND RECHECK TOUCH PANEL

3.CHECK TOUCH SWITCH (OPERATION CHECK)
a.
E176521

Enter the "Touch Switch Check" screen. Refer to Check Touch Switch in Operation Check.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>OPERATION CHECK


b.

Touch the display in the area where the switch malfunction occurs.

OK:

A "+" mark appears at the touched position.



Result:
Proceed to
OK
NG



OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE