This DTC is output when there is a malfunction in the door pulse sensor system inside the slide door motor unit LH (slide door ECU LH) and a normal waveform is not input to the door pulse sensor during a power slide door operation.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2224 | Power Slide Door Pulse Sensor Malfunction on Rear Left Door | Door sensor malfunction in slide door motor unit LH (slide door ECU LH) | Slide door motor unit LH (slide door ECU LH) |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
If the replacement, removal and installation of the slide door motor unit or disconnection of the connectors of the slide door motor unit has been performed, initialize the power slide door system.
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR SYSTEM>INITIALIZATION
Clear the DTC.
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR SYSTEM>DTC CHECK / CLEAR
Check for DTC.
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR SYSTEM>DTC CHECK / CLEAR
DTC B2224 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG