This DTC is output when the slide door motor unit RH (slide door ECU RH) detects a malfunction in the power slide door sensor assembly RH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B222C | Rear Power Slide Door RH Touch Sensor Circuit | Malfunction detected in power slide door sensor assembly RH | ·
Power slide door sensor assembly RH ·
Slide door motor unit RH (slide door ECU RH) ·
Harness or connector |
If the replacement, removal and installation of the slide door motor unit or disconnection of the connectors of the slide door motor unit has been performed, initialize the power slide door system.
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR SYSTEM>INITIALIZATION
Clear the DTC.
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR SYSTEM>DTC CHECK / CLEAR
Check for DTC.
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR SYSTEM>DTC CHECK / CLEAR
DTC B222C is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Read the Data List according to the display on the GTS.
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Normal Condition | Reference Value | Diagnostic Note |
|---|---|---|---|---|
| PSD Touch Sensor | Power slide door sensor assembly RH signal | OFF, ON or Open | OFF: Power slide door sensor assembly RH not pressed
ON: Power slide door sensor assembly RH pressed Open: Power slide door sensor assembly RH open |
- |
| Tester Display |
|---|
| PSD Touch Sensor |
On the GTS screen, ON or OFF is displayed accordingly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the power slide door sensor assembly RH.
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR TOUCH SENSOR (except Wagon)>REMOVAL
Inspect the power slide door sensor assembly RH.
Click hereVehicle Exterior>DOOR / HATCH>POWER SLIDE DOOR TOUCH SENSOR (except Wagon)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the S4 slide door motor unit RH (slide door ECU RH) connector.
Disconnect the U2 power slide door sensor assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| S4-10 (OS) - U2-1 (OS) | Always | Below 1 Ω |
| S4-2 (OSG) - U2-2 (OSG) | Always | Below 1 Ω |
| S4-10 (OS) or U2-1 (OS) - Body ground | Always | 10 kΩ or higher |
| S4-2 (OSG) or U2-2 (OSG) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG