Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM › 2019.02–2019.06
RM35X0E _58 Vehicle Interior _078381 LIGHTING (INT) _0380033 LIGHTING SYSTEM D

LIGHTING (INT)  LIGHTING SYSTEM  OPERATION CHECK  


INSPECT ILLUMINATED ENTRY SYSTEM OPERATION


NOTICE:

Perform this inspection with the customize parameters at the initial settings.

Click hereVehicle Interior>LIGHTING (INT)>LIGHTING SYSTEM>CUSTOMIZE PARAMETERS


HINT:

Perform this inspection with the door switch is turned on.

Lights Controlled by Illuminated Entry System
Control Condition Lights that Operate

*1: w/o Overhead Console

*2: w/ Overhead Console

*3: w/ Immobiliser System

*4: w/ No. 1 Room Light for Center

*5: w/o Immobiliser System

*6: w/ Step Light for LED Type

*7: w/ Step Light for Bulb Type

*8: w/ Back Door Inside Handle Light

Door Lock/Unlock-linked
w/ Ignition Linked Automatic Door Unlock Function

With the ignition switch off and all of the doors closed and locked, unlock either front door using an unlock operation (key-linked or wireless operation) and check that the lights that operate turn on for 15 seconds and then turn off.


w/ Ignition Linked Automatic Door Unlock Function
·

Map light assembly*1

·

Map light sub-assembly*2

·

Transponder key coil*3


w/o Ignition Linked Automatic Door Unlock Function

With the ignition switch off and all of the doors closed and locked, unlock any door using an unlock operation (key-linked or wireless operation) and check that the lights that operate turn on for 15 seconds and then turn off.


w/o Ignition Linked Automatic Door Unlock Function
·

Map light assembly*1

·

Map light sub-assembly*2

·

Transponder key coil*3

·

No. 1 room light assembly (for Front)

·

No. 1 room light assembly (for Center)*4

·

No. 1 room light assembly (for Rear)


Door Open/Close-linked
w/ Ignition Linked Automatic Door Unlock Function

With the ignition switch off and all of the doors closed, open either front door and check that the lights that operate turn ON. While the lights that operate are on, close all of the doors and check that the lights that operate turn off after approximately 15 seconds.


w/ Ignition Linked Automatic Door Unlock Function
·

Map light assembly*1

·

Map light sub-assembly*2

·

Transponder key coil*3

·

Key cylinder light assembly*5


w/ Ignition Linked Automatic Door Unlock Function

With the ignition switch off and all of the doors closed, open back door and check that the lights that operate turn ON. While the lights that operate are on, close all of the doors and check that the lights that operate turn off after approximately 15 seconds.


w/ Ignition Linked Automatic Door Unlock Function
·

No. 1 interior illumination light assembly LH*6

·

No. 1 interior illumination light assembly RH*6

·

No. 2 room light assembly*7

·

No. 1 room light assembly (for Front)

·

No. 1 room light assembly (for Center)*4

·

No. 1 room light assembly (for Rear)

·

Back door inside handle bezel*8


w/o Ignition Linked Automatic Door Unlock Function

With the ignition switch off and all of the doors closed, open any door, slide door and check that the lights that operate turn ON. While the lights that operate are on, close all of the doors and check that the lights that operate turn off after approximately 15 seconds.


w/o Ignition Linked Automatic Door Unlock Function
·

Map light assembly*1

·

Map light sub-assembly*2

·

Transponder key coil*3

·

Key cylinder light assembly*5


w/o Ignition Linked Automatic Door Unlock Function

With the ignition switch off and all of the doors closed, open either rear door and check that the lights that operate turn ON. While the lights that operate are on, close all of the doors and check that the lights that operate turn off after approximately 15 seconds.


w/o Ignition Linked Automatic Door Unlock Function
·

No. 1 interior illumination light assembly LH*6

·

No. 1 interior illumination light assembly RH*6

·

No. 2 room light assembly*7


Ignition Switch-linked Turn the ignition switch from ACC or ON to off and check that the lights that operate turn on for approximately 15 seconds and then turn off.
w/ Ignition Linked Automatic Door Unlock Function
·

Map light assembly*1

·

Map light sub-assembly*2

·

Transponder key coil*3


w/o Ignition Linked Automatic Door Unlock Function
·

Map light assembly*1

·

Map light sub-assembly*2

·

Transponder key coil*3

·

No. 1 room light assembly (for Front)

·

No. 1 room light assembly (for Center)*4

·

No. 1 room light assembly (for Rear)





INSPECT BATTERY SAVING CONTROL OPERATION


a.

The operations and conditions of this control are described below.

Control Condition Lights that Operate

*1: w/o Overhead Console

*2: w/ Overhead Console

*3: w/ Immobiliser System

*4: w/ No. 1 Room Light for Center

*5: w/o Immobiliser System

*6: w/ Step Light for LED Type

*7: w/ Step Light for Bulb Type

*8: w/ Back Door Inside Handle Light

Basic operation (w/ Ignition Linked Automatic Door Unlock Function) When 30 minutes elapse after the ignition switch is turned from ACC or IG to off and the lights that operate remain on, the lights are turned off.
HINT:

Battery saving control is canceled when any of the following operations is performed before the lights are turned off by battery saving control. After the operation is performed, the lights remain on for another 30 minutes and then the lights are turned off.

·

The ignition switch is turned to ACC or IG.

·

Front door is opened and closed.

·

Back door is opened and closed.

·

Any door is unlocked.

·

Room light switch is turned to on.



·

Map light assembly*1

·

Map light sub-assembly*2

·

Transponder key coil*3

·

No. 1 interior illumination light assembly LH*6

·

No. 1 interior illumination light assembly RH*6

·

No. 2 room light assembly*7

·

No. 1 room light assembly (for Front)

·

No. 1 room light assembly (for Center)*4

·

No. 1 room light assembly (for Rear)

·

Back door inside handle bezel*8


Basic operation (w/o Ignition Linked Automatic Door Unlock Function) When 20 minutes elapse after the ignition switch is turned from ACC or IG to off and the lights that operate remain on, the lights are turned off.
HINT:

Battery saving control is canceled when any of the following operations is performed before the lights are turned off by battery saving control. After the operation is performed, the lights remain on for another 20 minutes and then the lights are turned off.

·

The ignition switch is turned to ACC or IG.

·

Any door is opened and closed.

·

Any door is unlocked.



·

Map light assembly*1

·

Map light sub-assembly*2

·

Transponder key coil*3

·

No. 1 room light assembly (for Front)

·

No. 1 room light assembly (for Center)*4

·

No. 1 room light assembly (for Rear)


Interior light auto cut operation (w/ Ignition Linked Automatic Door Unlock Function) When 30 minutes elapse after the ignition switch is turned from ACC or IG to off and the lights that operate remain on, the lights are turned off.
HINT:

Battery saving control is canceled when any of the following operations is performed before the lights are turned off by battery saving control. After the operation is performed, the lights remain on for another 30 minutes and then the lights are turned off.

·

The ignition switch is turned to ACC or IG.



·

Map light assembly*1

·

Map light sub-assembly*2

·

Transponder key coil*3

·

Key cylinder light assembly*5


Interior light auto cut operation (w/o Ignition Linked Automatic Door Unlock Function) When 20 minutes elapse after the ignition switch is turned from ACC or IG to off and the lights that operate remain on, the lights are turned off.
HINT:

Battery saving control is canceled when any of the following operations is performed before the lights are turned off by battery saving control. After the operation is performed, the lights remain on for another 20 minutes and then the lights are turned off.

·

The ignition switch is turned to ACC or IG.



·

Map light assembly*1

·

Map light sub-assembly*2

·

Key cylinder light assembly*5

·

No. 1 interior illumination light assembly LH*6

·

No. 1 interior illumination light assembly RH*6

·

No. 2 room light assembly*7

·

No. 1 room light assembly (for Front)

·

No. 1 room light assembly (for Center)*4

·

No. 1 room light assembly (for Rear)