Home › Vehicle Interior › LIGHTING (INT) › ROOM LIGHT SWITCH › 2019.02–2019.06
RM35X0E _58 Vehicle Interior _078381 LIGHTING (INT) _0381274 ROOM LIGHT SWITCH(w/ Rear Cooler) G

LIGHTING (INT)  ROOM LIGHT SWITCH(w/ Rear Cooler)  INSPECTION  


PROCEDURE

Hide 84172 1.INSPECT ROOM LIGHT SWITCH

a.
E416322C01
0.094,0.083 0.25,0.281 0.156,0.198 10 false *a
*a Component without harness connected
(Room Light Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 - 5 Room light switch off 10 kΩ or higher
2 - 5 Room light switch on Below 1 Ω


If the result is not as specified, replace the room light switch.


b.

Check the switch illumination.

i.
E416322C02
1,1.75 1.25,1.333 true 2.417,1.75 2.167,1.333 true 0.885,1.833 1.5,2.031 0.615,0.198 10 false ILL+ 2.385,1.833 3,2.031 0.615,0.198 10 false ILL- 0.083,0.083 0.333,0.333 0.25,0.25 10 false *a
*a Component without harness connected
(Room Light Switch)


Apply battery voltage to the connector and check that the switch illumination comes on.

OK:
Measurement Condition Condition Specified Condition
Battery positive (+) → 6 (ILL+)
Battery negative (-) → 1 (ILL-)
Always Switch illumination comes on


If the result is not as specified, replace the room light switch.