Home › Engine / Hybrid System › 7GR-FKS (ENGINE MECHANICAL) › FRONT CRANKSHAFT OIL SEAL
RM35X0E _51 Engine / Hybrid System _078603 7GR-FKS ENGINE MECHANICAL _0381341 FRONT CRANKSHAFT OIL SEAL A

7GR-FKS ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (w/ Air Conditioning System)

Hide 88703 3.DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY (w/ Air Conditioning System)

Hide 88704 4.DISCONNECT SUCTION HOSE SUB-ASSEMBLY (w/ Air Conditioning System)

Hide 16268 5.DISCONNECT NO. 1 WATER BY-PASS PIPE

a.
A443670

Slide the 2 hose clamps and disconnect the 2 water by-pass hoses from the oil cooler assembly.


b.

Remove the 3 bolts and nut and disconnect the No. 1 water by-pass pipe.


Hide 15609 6.REMOVE OIL FILTER BRACKET SUB-ASSEMBLY

Hide 13471 7.REMOVE CRANKSHAFT PULLEY

Hide 11301C 8.REMOVE FRONT CRANKSHAFT OIL SEAL

a.
A436688

Using a screwdriver, pry out the front crankshaft oil seal.

NOTICE:

Do not damage the surface of the front crankshaft oil seal press fit hole or crankshaft.


HINT:

Tape the screwdriver tip before use.