Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP (for 1GD-FTV)
RM35X0E _54 Brake _078668 BRAKE SYSTEM (OTHER) _0381545 VACUUM PUMP(for 1GD-FTV) A

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for 1GD-FTV)  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL VACUUM PUMP VANE

a.

Apply engine oil to the vacuum pump vane and vacuum pump vane caps and install the caps to the vacuum pump vane.


b.

Apply engine oil to the vacuum pump vane with vacuum pump vane caps and install it to the vacuum pump housing.

NOTICE:

When reusing the vacuum pump vane and 2 vacuum pump vane caps, install them in the same position and orientation as when they were removed.



Hide 2.INSTALL END COVER

a.
C334237C01
2.094,2.875 2.635,2.188 2.635,2.188 2.865,2.188 false 2.917,2.115 3.094,2.292 0.177,0.177 10 false *1
*1 No. 1 O-ring


Install a new No. 1 O-ring to the vacuum pump assembly.

NOTICE:
·

Wipe off any oil on the vacuum pump end cover installation surface and end cover.

·

Check that on foreign matter is on the No. 1 O-ring or inside the vacuum pump housing.




b.

Using a T30 "TORX" socket wrench, install the end cover with 5 new screws.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:
·

Hold the pump so that the pump installation surface, fitting parts and oil pump will not be damaged.

·

As the housing deforms when force is applied, do not clamp the housing with a tool such as a vise.




c.
C334238

Turn the coupling clockwise as shown in the illustration and check that the coupling is not stuck or that there is no abnormal resistance.