Home › Engine / Hybrid System › 7GR-FKS (ENGINE CONTROL) › THROTTLE BODY
RM35X0E _51 Engine / Hybrid System _078720 7GR-FKS ENGINE CONTROL _0381914 THROTTLE BODY A

7GR-FKS ENGINE CONTROL  THROTTLE BODY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during throttle body with motor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 17705 2.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 22030 3.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

a.
A443194

Slide the hose clamp and disconnect the No. 4 water by-pass hose from the throttle body with motor assembly.


b.
A443195

Slide the hose clamp and disconnect the No. 5 water by-pass hose from the throttle body with motor assembly.


c.
A443196

Disconnect the connector from the throttle body with motor assembly.


d.

Remove the 4 bolts, the throttle body with motor assembly and the gasket.

NOTICE:

If the throttle body with motor assembly has been struck or dropped, replace it.