The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during VVT sensor removal/installation are shown below.
17190
1.REMOVE INTAKE AIR SURGE TANK ASSEMBLY
2.REMOVE AIR SWITCHING VALVE ASSEMBLY (w/ Secondary Air Injection System)
11401Q
3.REMOVE VVT SENSOR (for Intake Side of Bank 1)
w/o Secondary Air Injection System:
Disconnect the connector from the VVT sensor.
Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.
If the VVT sensor has been struck or dropped, replace it.
w/ Secondary Air Injection System:
Disconnect the connector from the VVT sensor.
Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.
If the VVT sensor has been struck or dropped, replace it.
11401M
4.REMOVE VVT SENSOR (for Exhaust Side of Bank 1)
w/o Secondary Air Injection System:
Disconnect the connector from the VVT sensor.
Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.
If the VVT sensor has been struck or dropped, replace it.
w/ Secondary Air Injection System:
Disconnect the connector from the VVT sensor.
Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.
If the VVT sensor has been struck or dropped, replace it.
11401M
5.REMOVE VVT SENSOR (for Intake Side of Bank 2)
w/o Secondary Air Injection System:
Disconnect the connector from the VVT sensor.
Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.
If the VVT sensor has been struck or dropped, replace it.
w/ Secondary Air Injection System:
Disconnect the connector from the VVT sensor.
Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.
If the VVT sensor has been struck or dropped, replace it.
11401M
6.REMOVE VVT SENSOR (for Exhaust Side of Bank 2)
w/o Secondary Air Injection System:
Disconnect the connector from the VVT sensor.
Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.
If the VVT sensor has been struck or dropped, replace it.
w/ Secondary Air Injection System:
Disconnect the connector from the VVT sensor.
Remove the bolt and VVT sensor from the cylinder head cover sub-assembly.
If the VVT sensor has been struck or dropped, replace it.