Home › Engine / Hybrid System › 7GR-FKS (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM35X0E _51 Engine / Hybrid System _078720 7GR-FKS ENGINE CONTROL _0381922 CRANKSHAFT POSITION SENSOR A

7GR-FKS ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11401G 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

NOTICE:

If reusing the crankshaft position sensor, be sure to inspect the O-ring.



b.
A443222

Install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the crankshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.




c.

Connect the connector to the crankshaft position sensor.


Hide 51405A 2.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 52618 3.INSTALL LOWER FRONT BUMPER ABSORBER

Hide 51406A 4.INSTALL NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)