Home › Engine / Hybrid System › 7GR-FKS (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM35X0E _51 Engine / Hybrid System _078720 7GR-FKS ENGINE CONTROL _0381922 CRANKSHAFT POSITION SENSOR A

7GR-FKS ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 51406A 1.REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ No. 2 Engine Under Cover Sub-assembly)

Hide 52618 2.REMOVE LOWER FRONT BUMPER ABSORBER

Hide 51405A 3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 11401G 4.REMOVE CRANKSHAFT POSITION SENSOR

a.
A443222

Disconnect the connector from the crankshaft position sensor.


b.

Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.

NOTICE:

If the crankshaft position sensor has been struck or dropped, replace it.