The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ignition coil assembly or spark plug removal/installation are shown below.
17190
1.REMOVE INTAKE AIR SURGE TANK ASSEMBLY
2.REMOVE AIR SWITCHING VALVE ASSEMBLY (w/ Secondary Air Injection System)
12601B
3.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Remove the bolt and No. 1 engine cover sub-assembly.
82715
4.REMOVE WIRE HARNESS CLAMP BRACKET
Detach the 2 wire harness clamps to disconnect the wire harness from the wire harness clamp bracket.
Remove the bolt and wire harness clamp bracket.
19500
5.REMOVE IGNITION COIL ASSEMBLY
Disconnect the 6 connectors from the 6 ignition coil assemblies.
Remove the 6 bolts and 6 ignition coil assemblies.
19100P
6.REMOVE SPARK PLUG
Remove the 6 spark plugs from the cylinder head sub-assembly.
If a spark plug has been struck or dropped, replace it.