The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air fuel ratio sensor removal/installation are shown below.
11209
1.REMOVE V-BANK COVER SUB-ASSEMBLY (w/ Cover)
89467B
2.REMOVE AIR FUEL RATIO SENSOR (for Bank 2)
w/o Secondary Air Injection System:
Disconnect the air fuel ratio sensor connector.
Detach the wire harness clamp.
Using SST, remove the air fuel ratio sensor.
If the air fuel ratio sensor has been struck or dropped, replace it.
w/ Secondary Air Injection System:
Disconnect the air fuel ratio sensor connector.
Detach the wire harness clamp.
Using SST, remove the air fuel ratio sensor.
If the air fuel ratio sensor has been struck or dropped, replace it.
89467C
3.REMOVE AIR FUEL RATIO SENSOR (for Bank 1)
w/o Secondary Air Injection System:
Disconnect the air fuel ratio sensor connector.
Detach the wire harness clamp.
Using SST, remove the air fuel ratio sensor.
If the air fuel ratio sensor has been struck or dropped, replace it.
w/ Secondary Air Injection System:
Disconnect the air fuel ratio sensor connector.
Detach the 3 wire harness clamps.
Using SST, remove the air fuel ratio sensor.
If the air fuel ratio sensor has been struck or dropped, replace it.