Home › Engine / Hybrid System › 1GD-FTV (STARTING) › GLOW PLUG CONTROLLER › 2019.02–2019.06
RM35X0E _51 Engine / Hybrid System _078666 1GD-FTV STARTING _0382048 GLOW PLUG CONTROLLER A

1GD-FTV STARTING  GLOW PLUG CONTROLLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the glow plug controller removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative when not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes). (Click here)
Lane control system Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative when not Performed Necessary Procedures Link
Power slide door system Fully close the slide door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the slide door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 28551 3.REMOVE GLOW PLUG CONTROLLER

a.
A437477

for LHD:

i.

Disconnect the 4 connectors and detach the 2 clamps from the glow plug controller.


ii.

Remove the 2 nuts and glow plug controller.



b.
A437478

for RHD:

i.

Disconnect the 4 connectors and detach the clamp from the glow plug controller.


ii.

Remove the 2 nuts and glow plug controller.



Hide 4.REMOVE WIRE HARNESS CLAMP BRACKET (for LHD)

a.
A437479

Remove the bolt and wire harness clamp bracket from the glow plug controller bracket.


Hide 28559 5.REMOVE GLOW PLUG CONTROLLER BRACKET

a.
A437480

for LHD:

i.

Remove the 4 screws and 2 glow plug controller brackets from the glow plug controller.



b.
A437481

for RHD:

i.

Remove the 4 screws and 2 glow plug controller brackets from the glow plug controller.