Home › Engine / Hybrid System › 1GD-FTV (STARTING) › STARTER (for 2.0 kW Type)
RM35X0E _51 Engine / Hybrid System _078666 1GD-FTV STARTING _0382050 STARTER(for 2.0 kW Type) A

1GD-FTV STARTING  STARTER(for 2.0 kW Type)  DISASSEMBLY  


PROCEDURE

Hide 28150 1.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A341308

Remove the nut and disconnect the lead wire from terminal C.


b.
A341309

Remove the 2 nuts from the repair service starter kit while holding the magnet starter switch assembly.


c.
A341310

Pull the magnet starter switch assembly and, while lifting the front part of the magnet starter switch assembly, release the plunger hook from the starter pinion drive lever and remove the magnet starter switch assembly.


Hide 28120 2.REMOVE STARTER YOKE ASSEMBLY

a.
A341311

Using a T25 "TORX" socket wrench, remove the 2 bolts.


b.
A341312

Remove the starter yoke assembly and starter commutator end frame assembly from the repair service starter kit.


Hide 3.REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY

a.
A341313

Remove the 2 screws from the starter commutator end frame assembly.


b.
A377034

Remove the starter commutator end frame assembly from the starter yoke assembly.

NOTICE:

While holding down the lead wire, remove the starter commutator end frame assembly.



Hide 28140 4.REMOVE STARTER BRUSH HOLDER ASSEMBLY

a.
A368709

Remove the starter brush holder assembly from the starter armature assembly.

NOTICE:

When removing the starter brush holder assembly, be careful not to damage the brush and commutator.



Hide 28160 5.REMOVE STARTER ARMATURE ASSEMBLY

a.
A202438

Remove the starter armature assembly from the starter yoke assembly.


Hide 28226B 6.REMOVE REPAIR SERVICE STARTER KIT

a.
A341314

Remove the starter armature plate from the starter yoke assembly or repair service starter kit.


b.
A341315

Remove the 3 planetary gears from the repair service starter kit.


c.
A356494

Remove the rubber seal from the repair service starter kit.