Home › Drivetrain › RC60J (MANUAL TRANSMISSION / TRANSAXLE) › INTELLIGENT MANUAL TRANSMISSION SWITCH
RM35X0E _52 Drivetrain _078740 RC60J MANUAL TRANSMISSION / TRANSAXLE _0382062 INTELLIGENT MANUAL TRANSMISSION SWITCH G

RC60J MANUAL TRANSMISSION / TRANSAXLE  INTELLIGENT MANUAL TRANSMISSION SWITCH  INSPECTION  


PROCEDURE

Hide 84720J 1.INSPECT PATTERN SELECT SWITCH ASSEMBLY (INTELLIGENT MANUAL TRANSMISSION SWITCH)

a.
C410217C01
1.344,1.865 1.344,1.302 true 2.104,1.865 2.104,1.302 true 2.073,1.865 2.292,2.094 0.219,0.229 10 false E 1.302,1.875 1.521,2.104 0.219,0.229 10 false S 0.042,0.031 0.313,0.271 0.271,0.24 10 false *a
*a Component without harness connected
(Pattern Select Switch Assembly (Intelligent Manual Transmission Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (S) - 2 (E) iMT switch pushed and hold Below 1 Ω
5 (S) - 2 (E) iMT switch not pushed 10 kΩ or higher


If the result is not as specified, replace the pattern select switch assembly (intelligent manual transmission switch).


b.
C410217C02
1.094,1.844 1.094,1.302 true 2.354,1.844 2.354,1.302 true 0.052,0.042 0.313,0.26 0.26,0.219 10 false *a 1.01,1.865 1.385,2.094 0.375,0.229 10 false ILL+ 2.292,1.854 2.667,2.083 0.375,0.229 10 false ILL-
*a Component without harness connected
(Pattern Select Switch Assembly (Intelligent Manual Transmission Switch))


Apply battery voltage between the terminals of the switch, and check the illumination condition of the pattern select switch assembly (intelligent manual transmission switch).

Standard:
Measurement Condition Specified Condition
Battery positive (+) → 6 (ILL+) Battery negative (-) → 1 (ILL-) Illuminates


If the result is not as specified, replace the pattern select switch assembly (intelligent manual transmission switch).