Home › Drivetrain › RC60J (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSMISSION UNIT
RM35X0E _52 Drivetrain _078740 RC60J MANUAL TRANSMISSION / TRANSAXLE _0382063 MANUAL TRANSMISSION UNIT G

RC60J MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSMISSION UNIT  INSPECTION  


PROCEDURE

Hide 33461 1.INSPECT REVERSE IDLER GEAR RADIAL CLEARANCE

a.
C334394

Using a dial indicator, measure the radial clearance.

Standard Clearance:

0.015 to 0.056 mm (0.000591 to 0.00220 in.)


Maximum Clearance:

0.056 mm (0.00220 in.)


If the clearance is more than the maximum, replace the needle roller bearing.


Hide 33369B 2.INSPECT NO. 4 SYNCHRONIZER RING

a.
F051608

Using a feeler gauge, measure the clearance between the No. 4 synchronizer ring and gear spline.

Standard Clearance:

0.82 to 1.48 mm (0.0323 to 0.0582 in.)


Minimum Clearance:

0.82 mm (0.0323 in.)


If the clearance is less than the minimum, replace the No. 4 synchronizer ring.


b.

Coat the output shaft cone with gear oil.


c.
F051609

Check the braking effect of the synchronizer ring.

i.

Turn the synchronizer ring in both directions while pushing it against the output shaft cone. Check that the ring locks in both directions. If No. 4 synchronizer ring turns, replace it.



Hide 33461 3.INSPECT REVERSE IDLER GEAR

a.
C415438

Install the reverse idler gear with the reverse idler gear shaft bolt.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)


b.
C325393

Using a feeler gauge, measure the thrust clearance.

Standard Clearance:

0.196 to 0.939 mm (0.00772 to 0.0369 in.)


Maximum Clearance:

0.939 mm (0.0369 in.)


If the clearance is more than the maximum, replace the reverse idler gear shaft, reverse idler gear or manual transmission case sub-assembly.


c.

Remove the reverse idler gear.