Home › Drivetrain › RC60J (MANUAL TRANSMISSION / TRANSAXLE) › OUTPUT SHAFT
RM35X0E _52 Drivetrain _078740 RC60J MANUAL TRANSMISSION / TRANSAXLE _0382065 OUTPUT SHAFT G

RC60J MANUAL TRANSMISSION / TRANSAXLE  OUTPUT SHAFT  INSPECTION  


PROCEDURE

Hide 33321 1.INSPECT OUTPUT SHAFT

a.
F051607

Using a cylinder gauge, measure the inside diameter of the output shaft.

Standard Inside Diameter:

45.009 to 45.025 mm (1.7721 to 1.7726 in.)


Maximum Inside Diameter:

45.025 mm (1.7726 in.)


If the diameter is more than the maximum, replace the output shaft.