Home › Drivetrain › CLUTCH › CLUTCH SYSTEM
RM35X0E _52 Drivetrain _078837 CLUTCH _0382375 CLUTCH SYSTEM N

CLUTCH  CLUTCH SYSTEM  BLEEDING  


CAUTION / NOTICE / HINT

NOTICE:

Wash off clutch fluid immediately if it comes in contact with any painted surface.


HINT:
·

If any work is performed on the clutch system or if air in the clutch lines is suspected, bleed air from the clutch hydraulic system.

·

In case of clutch fluid replacement, make sure that the old fluid is replaced in the clutch line between the reservoir and the bleeder before bleeding.



PROCEDURE

Hide 1.FILL RESERVOIR WITH BRAKE FLUID

Hide 2.BLEED CLUTCH LINE

C413182C01
2.354,0.906 2.552,1.177 2.552,1.177 2.708,1.177 true 2.198,0.896 2.021,0.552 2.021,0.552 1.844,0.552 true 1.948,3.208 1.771,2.865 1.771,2.865 1.594,2.865 true 2.365,3.656 2.188,3.313 2.188,3.313 2.01,3.313 true 0.156,0.125 0.469,0.323 0.313,0.198 10 true *A 0.198,2.448 0.51,2.646 0.313,0.198 10 true *B 2.75,1.083 2.958,1.271 0.208,0.188 10 true *1 1.615,0.458 1.823,0.646 0.208,0.188 10 true *2 1.365,2.771 1.573,2.958 0.208,0.188 10 true *1 2.365,3.667 2.573,3.854 0.208,0.188 10 true *2
*A for 7GR-FKS
*B for 1GD-FTV
*1 Bleeder Plug Cap
*2 Bleeder Plug


a.

Remove the bleeder plug cap.


b.

Connect a vinyl tube to the bleeder plug.


c.

Depress the clutch pedal 5 times, and then loosen the bleeder plug while the pedal is depressed. *1


d.

When fluid no longer comes out, tighten the bleeder plug, and then release the clutch pedal. *2


e.

Repeat steps *1 and *2 until all the air in the brake fluid is completely bled out.

NOTICE:

Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while replacing the brake fluid.



f.

Check that all the air has been bled from the clutch line.


g.

Tighten the bleeder plug.

Torque:
for 7GR-FKS : 10.8 N*m (110 kgf*cm, 8 ft.*lbf)
for 1GD-FTV : 8.4 N*m (86 kgf*cm, 74 in.*lbf)


h.

Depress the clutch pedal 10 times or more and confirm its operation.

NOTICE:

This must be performed before the engine is started.



i.

Install the bleeder plug cap.


Hide 3.INSPECT FLUID LEAK

Hide 4.INSPECT BRAKE FLUID LEVEL IN RESERVOIR