Home › Drivetrain › CLUTCH › CLUTCH UNIT
RM35X0E _52 Drivetrain _078837 CLUTCH _0382379 CLUTCH UNIT G

CLUTCH  CLUTCH UNIT  INSPECTION  


PROCEDURE

Hide 31250 1.INSPECT CLUTCH DISC ASSEMBLY

C410747

a.

Using a vernier caliper, measure the rivet head depth.

Minimum rivet depth:

0.3 mm (0.0118 in.)


If the depth is less than the minimum, replace the clutch disc assembly.


b.

Install the clutch disc assembly onto the manual transmission assembly.

HINT:

Insert the clutch disc assembly in the correct direction.



c.
C410748

Using a dial gauge, measure the clutch disc assembly runout.

Maximum runout:

0.8 mm (0.0315 in.)


If the runout is more than the maximum, replace the clutch disc assembly.


Hide 31210 2.INSPECT CLUTCH COVER ASSEMBLY

C410749C01
0,2.25 3.417,2.25 false 0.25,0.552 0.406,0.75 0.156,0.198 10 false A 0.979,0.292 1.135,0.49 0.156,0.198 10 false B 0.99,2.698 1.146,2.896 0.156,0.198 10 false B 0.24,2.969 0.396,3.167 0.156,0.198 10 false A 0.052,0.063 0.365,0.26 0.313,0.198 10 false *A 0.073,2.385 0.385,2.583 0.313,0.198 10 false *B
*A for 7GR-FKS
*B for 1GD-FTV


a.

Using a vernier caliper, measure the depth and width of the diaphragm spring wear.

Maximum depth A:

0.35 mm (0.0138 in.)


Maximum width B:

6.0 mm (0.236 in.)


If the depth or width is more than the maximum, replace the clutch cover assembly.


Hide 3.INSPECT FLYWHEEL

C410750

a.

Using a dial gauge, check the flywheel runout.

Maximum runout:

0.1 mm (0.00394 in.)


If the runout is more than the maximum, replace the flywheel.


Hide 31230 4.INSPECT CLUTCH RELEASE BEARING ASSEMBLY

a.
N000414

Turn the bearing by hand while applying force in the axial direction and check that the bearing rotates smoothly.

If the bearing sticks or a considerable amount of resistance is felt, replace the release bearing.

HINT:

The bearing is permanently lubricated and requires no cleaning or lubrication.



Hide 33311A 5.REPLACE INPUT SHAFT FRONT BEARING (for 1GD-FTV)

a.

Remove any 2 diametrically opposite bolts.


b.
C415955N01
1.021,0.917 1.323,0.219 true 1.375,0.125 1.833,0.323 0.458,0.198 10 false SST

Using SST, remove the input shaft front bearing.

SST
09303-35011  


c.
C415956N01
1.167,0.969 1.406,0.271 true 1.427,0.125 1.885,0.323 0.458,0.198 10 false SST

Using SST and a hammer, tap in a new input shaft front bearing.

SST
09304-12012  

HINT:

After installing the bearing to the crankshaft.



d.

Install the 2 bolts.

Torque:
178 N*m (1815 kgf*cm, 131 ft.*lbf)