84520
1.INSPECT CLUTCH START SWITCH ASSEMBLY
| *a | Component without harness connected
(Clutch Start Switch Assembly) |
| *b | 7.65 to 8.35 mm (0.302 to 0.328 in.) |
| *c | ON |
| *d | OFF |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | On (pushed) | Below 1 Ω |
| 1 - 2 | Off (not pushed) | 10 kΩ or higher |
If the result is not as specified, replace the clutch start switch assembly.
88280A
2.INSPECT CLUTCH SWITCH ASSEMBLY
| *a | Component without harness connected
(Clutch Switch Assembly) |
| *b | 6.5 to 7.5 mm (0.256 to 0.295 in.) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Pushed (On) | Below 1 Ω |
| 1 - 2 | Not pushed (Off) | 10 kΩ or higher |
If the result is not as specified, replace the clutch switch assembly.