The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear shock absorber assembly removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE REAR WHEEL
65638A
2.DISCONNECT REAR WHEEL HOUSE LINER (w/ Wheel House Liner)
Remove the 2 clips, grommet and disconnect the rear wheel house liner.
48540
3.REMOVE REAR SHOCK ABSORBER ASSEMBLY
Using a jack and wooden block, support the rear axle housing assembly.
Remove the 2 bolts.
Disconnect the rear shock absorber assembly and 4 rear shock absorber bushes from the spring U bolt seat and vehicle body.
Remove the 4 rear shock absorber bushes from the rear shock absorber assembly.
Remove the 2 rear shock absorber cushion washers.