The forward recognition camera receives vehicle information from the ECM via CAN communication.
If the forward recognition camera cannot store the vehicle information, it will store this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U030051 | Internal Control Module Software Incompatibility Not Programmed | When the ignition switch is ON for 3 seconds or more, the vehicle information sent from the ECM cannot be verified by the forward recognition camera for 3 seconds or more. | ·
Forward recognition camera ·
ECM |
When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.
If the forward recognition camera has been replaced with a new one, forward recognition camera adjustment must be performed.
Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.
One Time Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (ONE TIME RECOGNITION)
Sequential Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)
Using the GTS, check for SFI system or ECD system DTCs.
| Result | Proceed to |
|---|---|
| SFI or ECD system DTCs are not output | A |
| SFI system DTCs are output | B |
| ECD system DTCs are output | C |
A
B
Click hereEngine / Hybrid System>7GR-FKS (ENGINE CONTROL)>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
C
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: System Select / Health Check.
Check DTCs.
Turn the ignition switch off.
DTCs indicating a vehicle information mismatch with the ECM are not output by any ECU other than the forward recognition camera.
| Proceed to |
|---|
| DTC is output |
| DTC is not output |
DTC is output
DTC is not output
for 7GR-FKS: Click hereEngine / Hybrid System>7GR-FKS (ENGINE CONTROL)>ECM>REMOVAL
for 1GD-FTV: Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECM>REMOVAL