| Front Camera Unavailable
|
X2000
|
Yaw Rate Sensor Malfunction
|
The forward recognition camera received a yaw rate sensor malfunction signal from the skid control ECU (brake actuator assembly).
|
Perform troubleshooting for the electronically controlled brake system.
( )
|
| Front Camera Unavailable
|
X2004
|
Speed Sensor Malfunction
|
The forward recognition camera received a vehicle speed sensor malfunction signal from the skid control ECU (brake actuator assembly).
|
Perform troubleshooting for the electronically controlled brake system.
( )
|
| Pre-Collision System Malfunction Visit Your Dealer
|
X2014
|
Front Recognition Camera Optical Axis Not Adjusted
|
Forward recognition camera optical axis adjustment has not been performed.
|
- HINT:
-
Forward recognition camera adjustment can be performed by using either One Time Recognition or Sequential Recognition.
-
One Time Recognition: Click here( )
-
Sequential Recognition: Click here( )
|
| Front Camera Unavailable See Owner's Manual
|
X2015
|
Front Recognition Camera Dirt
|
System operation was temporarily suspended due to the forward recognition camera not being able to detect objects.
|
Check if any of the following conditions are met:
·
Non-Toyota genuine front wiper blades are installed
·
The front wiper rubbers are worn
·
A sticker, accessory or other object is obstructing the forward recognition camera
·
There is snow, frost, dirt, dust or oil on the windshield glass, or the windshield glass is fogged up
·
The windshield glass is chipped or cracked
·
Non-Toyota genuine windshield glass is installed
·
Confirm the vehicle was not driven in bad weather (If temporary conditions that affected the camera such as darkness, backlighting, fog, etc. have improved, the displayed warning is cleared).
Factor:
The area in front of the forward recognition camera is dirty or obstructed by foreign matter.
|
| Front Camera Unavailable
|
X2016
|
Front Recognition Camera Outside Guaranteed Operating Temperature
|
System operation was temporarily suspended due to the forward recognition camera being excessively hot or cold.
|
Use the GTS to check the following front camera system Data List items. If the value is "High Temperature" or "Low Temperature", refer to ( ).
·
Front Recognition Camera Low Temperature
·
Front Recognition Camera High Temperature 1
|
| Front Camera Unavailable
|
X2017
|
Front Recognition Camera Outside Guaranteed Operating Voltage
|
System operation was temporarily suspended due to forward recognition camera power source voltage being excessively high or low.
|
Check the power source voltage of the forward recognition camera (terminal IGB). Refer to ( ) for the terminal inspection and standard voltage. If the power source voltage is within the specified range, the forward recognition camera may be malfunctioning.
|
| Front Camera Unavailable See Owner's Manual
|
X201C
|
Front Recognition Camera Haze
|
System operation was temporarily suspended due to forward recognition camera not being able to detect objects.
|
Check if any of the following conditions are met:
·
Non-Toyota genuine front wiper blades are installed
·
The front wiper rubbers are worn
·
A sticker, accessory or other object is obstructing the forward recognition camera
·
There is snow, frost, dirt, dust or oil on the windshield glass, or the windshield glass is fogged up
·
The windshield glass is chipped or cracked
·
Non-Toyota genuine windshield glass is installed
·
Confirm the vehicle was not driven in bad weather (If temporary conditions that affected the camera such as darkness, backlighting, fog, etc. have improved, the displayed warning is cleared).
Factor:
The area in front of the forward recognition camera is dirty or obstructed by foreign matter.
|
| Front Camera Unavailable
|
X204A
|
Acceleration Sensor Malfunction
|
The forward recognition camera received an acceleration sensor malfunction signal from the skid control ECU (brake actuator assembly).
|
Perform troubleshooting for the electronically controlled brake system.
( )
|
| Front Camera Unavailable
|
X204C
|
Zero Point Calibration of Yaw Rate Sensor Undone
|
The forward recognition camera received a yaw rate sensor zero point calibration not performed signal from the skid control ECU (brake actuator assembly).
|
Perform troubleshooting for the electronically controlled brake system.
( )
|