Home › Drivetrain › RC60J (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSMISSION SYSTEM (for 7GR-FKS)
RM35X0E _52 Drivetrain _078740 RC60J MANUAL TRANSMISSION / TRANSAXLE _0383349 MANUAL TRANSMISSION SYSTEM(for 7GR-FKS) D

RC60J MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSMISSION SYSTEM(for 7GR-FKS)  DIAGNOSIS SYSTEM  


DESCRIPTION


a.

To check DTCs, connect the GTS or OBD scan tool to the Data Link Connector 3 (DLC3) of the vehicle. The scan tool displays DTCs, freeze frame data and a variety of engine data.

The DTCs and freeze frame data can be cleared with the scan tool.

Click hereDrivetrain>RC60J (MANUAL TRANSMISSION / TRANSAXLE)>MANUAL TRANSMISSION SYSTEM (for 7GR-FKS)>DTC CHECK / CLEAR



FUNCTION OF WARNING INDICATOR


a.

If the iMT system is not functioning properly, the driver is warned by the iMT warning light in the combination meter assembly.

DTC iMT Indicator
(iMT System ON)
Detail
DTCs are stored iMT warning light (yellow) illuminates iMT system malfunction
DTCs are not stored iMT indicator light (green) illuminates iMT system standby condition



FREEZE FRAME DATA


The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data stored at the time of a malfunction.


CHECK DATA LINK CONNECTOR 3 (DLC3)




CHECK BATTERY VOLTAGE


Standard voltage:

11 to 14 V


If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.