Home › Engine / Hybrid System › 1GD-FTV (EMISSION CONTROL) › EXHAUST FUEL ADDITION INJECTOR
RM35X0E _51 Engine / Hybrid System _079220 1GD-FTV EMISSION CONTROL _0384161 EXHAUST FUEL ADDITION INJECTOR G

1GD-FTV EMISSION CONTROL  EXHAUST FUEL ADDITION INJECTOR  INSPECTION  


PROCEDURE

Hide 23710B 1.INSPECT EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 7.1 to 7.9 Ω


HINT:

The temperature indicated in "Condition" is the temperature of the exhaust fuel addition injector assembly.


If the result is not as specified, replace the exhaust fuel addition injector assembly.