Home › Engine / Hybrid System › 1GD-FTV (LUBRICATION) › OIL PRESSURE SWITCH
RM35X0E _51 Engine / Hybrid System _079221 1GD-FTV LUBRICATION _0384266 OIL PRESSURE SWITCH G

1GD-FTV LUBRICATION  OIL PRESSURE SWITCH  INSPECTION  


PROCEDURE

Hide 83530 1.INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Disconnect the connector from the engine oil pressure switch.


b.

Start the engine.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - Body ground Engine stopped Below 2.5 Ω
Engine idling 10 kΩ or higher


If the result is not as specified, replace the engine oil pressure switch assembly.


d.

Connect the connector to the engine oil pressure switch.