Home › General › MAINTENANCE › REAR TURN SIGNAL LIGHT BULB › 2019.02–2019.06
RM35X0E _V1 General _078672 MAINTENANCE _0384283 REAR TURN SIGNAL LIGHT BULB A

MAINTENANCE  REAR TURN SIGNAL LIGHT BULB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR COMBINATION LIGHT ASSEMBLY LH

a.
E413221C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the rear combination light assembly LH.


b.
E413219

Remove the 3 screws.


c.
E413222C01
0,0 0,0 false
V113146

Place Hands Here
V113147

Pull in this Direction


Place your hand at the location shown in the illustration and pull the rear combination light assembly LH toward the rear of the vehicle to detach the pin to remove it.


d.

Support the rear combination light assembly LH with one hand.


Hide 81550L 2.REMOVE REAR TURN SIGNAL LIGHT BULB

a.
E413327C01
1.135,0.76 1.354,1.125 true 2.906,0.479 3.094,0.333 true 1.406,1.073 1.604,1.25 0.198,0.177 10 true *a 3.135,0.24 3.333,0.417 0.198,0.177 10 true *b
*a Matchmark
*b Unlock Position Mark
V113147

Turn in this Direction


Turn the bulb socket counterclockwise until the matchmark is aligned with the unlock position mark to disconnect the bulb socket.


b.
E413331C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the rear turn signal light bulb from the bulb socket.