Home › General › MAINTENANCE › REAR TURN SIGNAL LIGHT BULB › 2019.02–2019.06
RM35X0E _V1 General _078672 MAINTENANCE _0384283 REAR TURN SIGNAL LIGHT BULB A

MAINTENANCE  REAR TURN SIGNAL LIGHT BULB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 81550L 1.INSTALL REAR TURN SIGNAL LIGHT BULB

a.
E413335C01
0,0 0,0 false
V113147

Install in this Direction


Install the rear turn signal light bulb to the bulb socket.


b.
E413339C01
1.396,1.021 1.063,0.563 true 0.875,0.26 1.167,0.469 true 3.073,1.083 3.01,0.76 true 1.375,1.031 1.688,1.188 0.313,0.156 10 false *a 0.677,0.156 0.865,0.323 0.188,0.167 10 true *b 3,1.104 3.188,1.281 0.188,0.177 10 true *c
*a Matchmark
*b Unlock Position Mark
*c Lock Position Mark
V113147

Turn in this Direction


Align the matchmark of the bulb socket with the unlock position mark, and then turn the bulb socket clockwise until the lock position mark to connect the bulb socket.


Hide 2.INSTALL REAR COMBINATION LIGHT ASSEMBLY LH

a.
E413223C01
0,0 0,0 false
V113147

Slide in this Direction
V100155

Protective Tape


Slide the rear combination light assembly LH towards the vehicle front to attach the pin.


b.

Remove the protective tape.


c.
E413219

Install the 3 screws.