41110
1.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY
Clean the contact surfaces of the rear differential carrier assembly and rear axle housing.
Install the rear differential carrier assembly and a new rear differential carrier gasket with the 10 nuts and 10 washers.
The rear differential carrier assembly is a heavy component. Make sure that it is supported securely.
Do not damage the installation surface when installing the rear differential carrier assembly.
The remaining oil may leak out when installing the rear differential carrier assembly.
Securely support the rear differential carrier assembly while performing this step to avoid excessively tilting or dropping the rear differential carrier assembly.
Install the bolts with the rear differential carrier assembly secured.
41196
2.INSTALL REAR DIFFERENTIAL DYNAMIC DAMPER
Install the rear differential dynamic damper to the rear differential carrier assembly with 2 new bolts.
Keep the rear differential dynamic damper free of oil and foreign matter.
3.INSTALL REAR AXLE SHAFT WITH BACKING PLATE LH
for Rear Disc Brake:
Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE SHAFT (for Rear Disc Brake)>INSTALLATION
for Rear Drum Brake:
Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE SHAFT (for Rear Drum Brake)>INSTALLATION
4.INSTALL REAR AXLE SHAFT WITH BACKING PLATE RH
Use the same procedure described for the LH side.
37100
5.INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
for Standard Roof:
Click hereDrivetrain>DRIVE SHAFT / PROPELLER SHAFT>PROPELLER SHAFT ASSEMBLY (for Standard Roof)>INSTALLATION
for High Roof:
Click hereDrivetrain>DRIVE SHAFT / PROPELLER SHAFT>PROPELLER SHAFT ASSEMBLY (for High Roof)>INSTALLATION
6.ADD DIFFERENTIAL OIL
7.BLEED BRAKE SYSTEM
8.ADJUST PARKING BRAKE
9.INSTALL REAR WHEEL
10.CHECK ABS SPEED SENSOR SIGNAL