Home › Engine / Hybrid System › 1GD-FTV (ENGINE MECHANICAL) › CYLINDER HEAD
RM35X0E _51 Engine / Hybrid System _079219 1GD-FTV ENGINE MECHANICAL _0384430 CYLINDER HEAD A

1GD-FTV ENGINE MECHANICAL  CYLINDER HEAD  REPAIR  


PROCEDURE

Hide 1.REPAIR INTAKE VALVE SEAT

NOTICE:
·

Repair the seat while checking the seating position.

·

Keep the lip free from foreign matter.

·

Take off the cutter gradually to make the intake valve seat smooth.



a.
A337457C01
1.969,0.51 2.146,0.51 2.146,0.51 2.792,0.667 true 2.969,1.656 3.281,1.813 0.313,0.156 10 false *a 1.75,0.417 2.052,0.646 0.302,0.229 10 false 45° 3.104,0.635 3.375,0.844 0.271,0.208 10 false 25°
*a Width


If the seating is too high on the intake valve face, use 25° and 45° cutters to correct the intake valve seat.


b.
A337458C01
2.552,0.646 2.771,0.146 2.771,0.146 2.938,0.146 true 2.969,1.656 3.281,1.813 0.313,0.156 10 false *a 2.979,0.073 3.271,0.292 0.292,0.219 10 false 70° 2.865,0.552 3.208,0.76 0.344,0.208 10 false 45°
*a Width


If the seating is too low on the intake valve face, use 70° and 45° cutters to correct the intake valve seat.


c.

Check that the intake valve seat contact is in the middle of the intake valve face and has the following width.

Standard width:

1.2 to 1.6 mm (0.0472 to 0.0630 in.)



Hide 2.REPAIR EXHAUST VALVE SEAT

NOTICE:
·

Repair the seat while checking the seating position.

·

Keep the lip free from foreign matter.

·

Take off the cutter gradually to make the exhaust valve seat smooth.



a.
A337459C01
1.906,0.573 2.083,0.573 2.083,0.573 2.76,0.688 true 2.969,1.635 3.281,1.792 0.313,0.156 10 false *a 1.688,0.479 2,0.677 0.313,0.198 10 false 45° 3.115,0.656 3.406,0.854 0.292,0.198 10 false 25°
*a Width


If the seating is too high on the exhaust valve face, use 25° and 45° cutters to correct the exhaust valve seat.


b.
A337460C01
2.573,0.583 2.719,0.135 2.719,0.135 2.917,0.135 true 2.979,1.625 3.292,1.781 0.313,0.156 10 false *a 2.979,0.052 3.365,0.271 0.385,0.219 10 false 75° 2.896,0.594 3.198,0.781 0.302,0.188 10 false 45°
*a Width


If the seating is too low on the exhaust valve face, use 75° and 45° cutters to correct the exhaust valve seat.


c.

Check that the seat contact is in the middle of the exhaust valve face and has the following width.

Standard width:

1.6 to 2.0 mm (0.0630 to 0.0787 in.)