Make sure to use Toyota Genuine Windshield Glass Adhesive (High Modulus Type) or equivalent.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
67668A
1.REMOVE SLIDE DOOR WINDOW GARNISH LH (for Full-trim, for Standard Roof)
Use the same procedure as for the RH side.
Click hereVehicle Exterior>DOOR / HATCH>SLIDE DOOR (except Wagon)>DISASSEMBLY
67668A
2.REMOVE SLIDE DOOR WINDOW GARNISH LH (for Full-trim, for High Roof)
Use the same procedure as for the RH side.
Click hereVehicle Exterior>DOOR / HATCH>SLIDE DOOR (except Wagon)>DISASSEMBLY
67693B
3.REMOVE SLIDE DOOR UPPER TRIM COVER LH (for Full-trim, for High Roof)
Use the same procedure as for the RH side.
Click hereVehicle Exterior>DOOR / HATCH>SLIDE DOOR (except Wagon)>DISASSEMBLY
67690C
4.REMOVE SLIDE DOOR TRIM BOARD ASSEMBLY LH (for Full-trim, for Standard Roof)
Use the same procedure as for the RH side.
Click hereVehicle Exterior>DOOR / HATCH>SLIDE DOOR (except Wagon)>DISASSEMBLY
67690C
5.REMOVE SLIDE DOOR TRIM BOARD ASSEMBLY LH (for Full-trim)
Use the same procedure as for the RH side.
Click hereVehicle Exterior>DOOR / HATCH>SLIDE DOOR (except Wagon)>DISASSEMBLY
62720B
6.REMOVE FRONT SIDE WINDOW ASSEMBLY LH
|
Protective Tape |
Apply protective tape to the outer surface of the door panel to prevent scratches.
When separating the front side window assembly LH from the door panel, be careful not to damage the vehicle paint or interior/exterior ornaments.
| *a | Matchmark |
When reusing the front side window assembly LH:
Place matchmarks over the glass and door panel at the locations indicated in the illustration.
Install the suction cups to the front side window assembly LH.
| *1 | Quarter Window Glass Spacer |
| *2 | Front Side Window Clip LH |
| *a | Piano Wire |
From the interior, insert a piano wire between the door panel and glass as shown in the illustration.
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
When separating the glass from the door panel, be careful not to damage the vehicle paint or interior/exterior ornaments.
Cut through the adhesive by pulling the piano wire around the front side window assembly LH.
Using suction cups, disconnect the quarter window glass spacer and front side window clip LH and remove the front side window assembly LH.
Do not drop the front side window assembly LH.
7.REMOVE NO. 1 QUARTER PANEL SPACER
Using a moulding remover, remove the 2 No. 1 quarter panel spacers from the door panel.