Home › Engine / Hybrid System › CRUISE CONTROL › MILLIMETER WAVE RADAR SENSOR › 2019.02–2019.06
RM35X0E _51 Engine / Hybrid System _078884 CRUISE CONTROL _0384730 MILLIMETER WAVE RADAR SENSOR A

CRUISE CONTROL  MILLIMETER WAVE RADAR SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during millimeter wave radar sensor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly
·

Lane control system

·

Road sign assist system

·

Front radar sensor system

·

Pre-collision system

·

Automatic high beam system


(Click here)

PROCEDURE

Hide 53101 1.REMOVE RADIATOR GRILLE SUB-ASSEMBLY

Hide 88211B 2.REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

NOTICE:

Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.


a.
B538505C01
0,0 0,0 false
V100135

Bolt
V100136

Screw


Remove the 2 bolts and screw.


b.

Detach the guide and remove the millimeter wave radar sensor assembly.