Before removing the blower assembly, set the air conditioning to recirculation mode.
1.REMOVE AIR CONDITIONER UNIT ASSEMBLY
87130D
2.REMOVE BLOWER ASSEMBLY (for LHD)
w/ PTC Heater:
| *A | for Automatic Air Conditioning System |
| *B | except Automatic Air Conditioning System |
Remove the screw.
Detach the guide and disconnect the blower assembly side of the No. 2 cooler wiring.
for Automatic Air Conditioning System:
Disconnect the connector from the No. 1 blower damper servo sub-assembly.
Detach the guide.
Remove the 2 screws.
| *A | except Automatic Air Conditioning System | *B | for Automatic Air Conditioning System |
Detach the claw and guide and remove the blower assembly.
87130D
3.REMOVE BLOWER ASSEMBLY (for RHD)
w/ PTC Heater:
Remove the screw.
Detach the guide and disconnect the blower assembly side of the No. 2 cooler wiring.
Remove the 2 screws.
Detach the claw and guide and remove the blower assembly.