Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR (for 1GD-FTV)
RM35X0E _58 Vehicle Interior _079316 HEATING / AIR CONDITIONING _0384887 COMPRESSOR(for 1GD-FTV) G

HEATING / AIR CONDITIONING  COMPRESSOR(for 1GD-FTV)  INSPECTION  


PROCEDURE

Hide 1.INSPECT COOLER COMPRESSOR WITH MAGNETIC CLUTCH ASSEMBLY

a.

Inspect the magnet clutch assembly.

i.
E415246C01
0.49,1.125 0.49,0.625 true 0.052,0.031 0.365,0.229 0.313,0.198 10 false *a 0.385,1.156 0.844,1.354 0.458,0.198 10 false MG+
*a Component without harness connected
(Cooler Compressor with Magnet Clutch Assembly)


Apply battery voltage to the clutch and check the operation of the clutch.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 3 (MG+)
Battery negative (-) → Body ground
Magnet clutch is engaged


If the value is not within the standard, perform the following inspections.


ii.
E430935C01
0.115,0.083 0.427,0.281 0.313,0.198 10 false *a
*a Component without harness connected
(Magnet Clutch Assembly)


Disconnect the wire harness of the cooler compressor with magnet clutch assembly and check that the magnet clutch assembly operates when battery voltage is applied to the connector terminal on the magnet clutch side.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Body ground
Magnet clutch is engaged


·

If the result is not as specified, replace the magnet clutch assembly.

·

If the magnet clutch assembly is normal, replace the cooler compressor with magnet clutch assembly.