Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB
RM35X0E _52 Drivetrain _079259 AXLE AND DIFFERENTIAL _0385113 FRONT AXLE HUB G

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 47313J 2.DISCONNECT FRONT FLEXIBLE HOSE

Hide 3.DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

Hide 43512 4.REMOVE FRONT DISC

Hide 5.INSPECT FRONT AXLE HUB BEARING LOOSENESS

a.
C409461

Using a dial indicator with magnetic base, check for looseness near the center of the front axle hub sub-assembly LH.

Maximum looseness:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the front axle hub sub-assembly LH and front speed sensor LH.



HINT:

If the looseness exceeds the maximum, replace the front axle hub sub-assembly LH.



Hide 6.INSPECT FRONT AXLE HUB RUNOUT

a.
C409462

Using a dial indicator with magnetic base, check for runout on the surface of the front axle hub sub-assembly outside the front axle hub bolts.

Maximum runout:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Make sure to set the tip of the dial indicator towards the outside of the front axle hub bolts.

·

Keep the magnet of the dial indicator away from the front axle hub sub-assembly and front speed sensor LH.



HINT:

If the runout exceeds the maximum, replace the front axle hub sub-assembly LH.



Hide 43512 7.INSTALL FRONT DISC

Hide 8.CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

Hide 47313J 9.CONNECT FRONT FLEXIBLE HOSE

Hide 10.INSTALL FRONT WHEEL