The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during steering knuckle removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1.REMOVE FRONT AXLE ASSEMBLY LH
43212
2.REMOVE STEERING KNUCKLE LH
Secure the front axle assembly between aluminum plates in a vise.
Do not overtighten the vise.
Remove the 4 bolts, front axle hub sub-assembly LH and front disc brake dust cover from the steering knuckle LH.
Do not drop the front axle hub sub-assembly LH.
Be careful not to damage the speed sensor rotor or contact surfaces.
Do not allow foreign matter to contact the speed sensor rotor or contact surfaces.