85143R
1.INSTALL REAR WIPER MOTOR GROMMET
| *a | Rear Wiper Motor Grommet Lip |
Apply MP grease to the entire surface of the rear wiper motor grommet lip.
Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.
| *a | Matchmark |
Install the rear wiper motor grommet as shown in the illustration.
| Area | Standard Condition |
|---|---|
| A | 20° |
Check that the matchmark is in the range shown in the illustration.
85110R
2.INSTALL REAR WIPER MOTOR ASSEMBLY
|
Bolt |
|
Connector |
Install the rear wiper motor assembly with the 3 bolts.
Attach the clamp and connect the connector.
Do not reuse the rear wiper motor assembly which has been subjected to an impact or dropped.
3.INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
| *a | Rear Wiper Arm Serrations |
| *b | Rear Wiper Motor Assembly Pivot Serrations |
When reusing the rear wiper arm and blade assembly:
Clean the rear wiper arm serrations.
Do not grind the rear wiper arm serrations.
When reusing the rear wiper motor assembly:
Using a wire brush, clean the rear wiper motor assembly pivot serrations.
Do not grind the rear wiper motor assembly pivot serrations.
Turn the ignition switch to ON.
Operate the rear wiper motor assembly and stop at the automatic stop (park) position.
Turn the ignition switch off.
| *a | Matchmark |
| *b | Stopped Position Marking |
Align the end of the rear wiper arm and blade assembly with the center of the assembly marking and install the rear wiper arm and blade assembly with the nut as shown in the illustration.
| Area | Standard Condition |
|---|---|
| A | 17 mm (0.669 in.) |
After the rear wiper motor assembly is stopped, check the automatic stop position after lifting the wiper blade 2 times.
Hold the rear wiper arm by hand while tightening the nut.
Stop the rear wiper motor assembly so that it is between the matchmark and the stopped position marking as shown in the illustration.
Turn the ignition switch to ON.
Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not come into contact with the vehicle body.
Turn the ignition switch off.
Raise the rear wiper arm 2 times and check that the tip of the rear wiper blade is within the range shown in the illustration.
|
Install in this Direction |
Lower the rear wiper arm head cap in the direction indicated by the arrow shown in the illustration and attach the claw.
|
Install in this Direction |
Slide the rear wiper arm head cap as shown in the illustration to attach the claw.
67760A
4.INSTALL BACK DOOR UPPER TRIM BOARD ASSEMBLY
for Regular:
Click hereVehicle Exterior>DOOR / HATCH>BACK DOOR (except Wagon)>REASSEMBLY
for Large:
Click hereVehicle Exterior>DOOR / HATCH>BACK DOOR (except Wagon)>REASSEMBLY