Home › Engine / Hybrid System › 1GD-FTV (FUEL) › FUEL INJECTOR › 2019.02–2019.06
RM35X0E _51 Engine / Hybrid System _079306 1GD-FTV FUEL _0385712 FUEL INJECTOR G

1GD-FTV FUEL  FUEL INJECTOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 23670 1.CHECK INJECTOR ASSEMBLY

a.

Start the engine and drive the vehicle until the engine coolant temperature reaches 60°C (140°F) or higher.


b.

Allow the engine to idle for 1 minute or more.


c.

Connect the GTS to the DLC3.


d.

Turn the GTS on.


e.

Enter the following menus: Powertrain / Engine / Data List / Target Injection Volume and Injector Feedback Value. #1 to #4.

Powertrain > Engine > Data List
Tester Display
Target Injection Volume
Injection Feedback Value #1
Injection Feedback Value #2
Injection Feedback Value #3
Injection Feedback Value #4
50003 372 981,977,978,979,980

f.

Read the values when the engine is idling.


g.

Check that the "Injector Feedback Value. #1 to #4" values are within the specification.

Standard:
Tester Display Engine Condition Specified Condition
Target Injection Volume Idling 3 to 15 mm3/st
Injector Feedback Value #1
Injector Feedback Value #2
Injector Feedback Value #3
Injector Feedback Value #4
Idling -5.0 to 5.0 mm3/st


If the result is not as specified, replace the fuel injector assembly.


Hide 2.CHECK INJECTOR COMPENSATION CODE

HINT:

If the injector compensation code is not correctly registered, it may cause malfunctions.



b.

Check that the compensation code of the installed injector assembly is the same as the code registered in the ECM. If the code is not the same, register the injector compensation code on the injector assembly.

Click hereEngine / Hybrid System>1GD-FTV (ENGINE CONTROL)>ECD SYSTEM (w/ DPF)>REGISTRATION