Home › Engine / Hybrid System › 1GD-FTV (FUEL) › FUEL FILTER
RM35X0E _51 Engine / Hybrid System _079306 1GD-FTV FUEL _0385715 FUEL FILTER G

1GD-FTV FUEL  FUEL FILTER  INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL FILTER ASSEMBLY

a.
A438498C01
2.042,1.219 1.896,1.219 1.896,1.219 1.677,1.667 true 2.104,1.115 2.302,1.292 0.198,0.177 10 true *b 0.156,0.177 0.354,0.354 0.198,0.177 10 true *a
*a Component without harness connected
(Level Warning Switch)
*b Connector


Inspect the level warning switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Float at upper end position Below 1 Ω
Float at lower end position 10 kΩ or higher


If the result is not as specified, replace the fuel filter assembly.



b.

Inspect the clogging switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 4 20°C (68°F) Below 1 Ω


If the result is not as specified, replace the fuel filter assembly.