Home › Engine / Hybrid System › 1GD-FTV (INTAKE / EXHAUST) › EXHAUST MANIFOLD W/ TURBOCHARGER
RM35X0E _51 Engine / Hybrid System _079307 1GD-FTV INTAKE / EXHAUST _0385721 EXHAUST MANIFOLD W/ TURBOCHARGER G

1GD-FTV INTAKE / EXHAUST  EXHAUST MANIFOLD W/ TURBOCHARGER  INSPECTION  


PROCEDURE

Hide 17201 1.VISUALLY CHECK TURBOCHARGER SUB-ASSEMBLY

a.
A347090C01
0.677,1.927 0.896,1.927 0.896,1.927 1.281,1.542 true 0.5,1.813 0.813,1.969 0.313,0.156 10 false *1
*1 Compressor Impeller


Check for deformation and cracks in the compressor impeller on the intake side.

If the compressor impeller is cracked or deformed, replace the turbocharger sub-assembly.


b.
A345088C01
0.802,3.5 1.719,3.5 true 0.635,3.385 0.948,3.542 0.313,0.156 10 false *1
*1 Turbine Wheel


Check for deformation and cracks in the turbine wheel on the exhaust side.

If the turbine wheel is cracked or deformed, replace the turbocharger sub-assembly.


Hide 17201 2.INSPECT AXIAL PLAY OF TURBINE SHAFT

a.
A345089

Using a dial indicator, insert the needle of the dial indicator into the exhaust side of the turbine shaft.

NOTICE:

Turbocharger sub-assembly and dial indicators are surely fixed when performing measurement.



b.

Move the turbine shaft in an axial direction and measure the axial play of the turbine shaft.

Maximum axial play:

0.11 mm (0.00433 in.)


If the axial play is more than the maximum, replace the turbocharger sub-assembly.


Hide 17201 3.CHECK TURBINE SHAFT ROTATION

a.
A345091

Rotate the turbine wheel on the exhaust side with your finger and check that it rotates smoothly.

HINT:

Even if it takes a little effort to rotate the turbine wheel, this is not a problem.


If the turbine wheel does not rotate smoothly, replace the turbocharger sub-assembly.


Hide 4.INSPECT TURBOCHARGER NOZZLE VANE CONTROL ACTUATOR

a.
A172495C05
1.458,0.365 1.896,0.563 0.438,0.198 1.917,1.333 2.51,1.073 false 0.792,1.073 1.406,1.323 false 0.552,0.969 0.865,1.167 0.313,0.198 10 false M+ 2.552,0.99 2.865,1.188 0.313,0.198 10 false M- 0.073,0.073 0.385,0.229 0.313,0.156 10 false *a 1.552,0.396 1.865,0.552 0.313,0.156 10 false E41
*a Component without harness connected
(Turbocharger Nozzle Vane Control Actuator)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E41-1 (M-) - E41-2 (M+) 20°C (68°F) 1 to 100 Ω


HINT:

The temperature indicated in "Condition" is the temperature of the turbocharger nozzle vane control actuator.


If the result is not as specified, replace the turbocharger nozzle vane control actuator.