Home › Engine / Hybrid System › 1GD-FTV (INTAKE / EXHAUST) › INTERCOOLER
RM35X0E _51 Engine / Hybrid System _079307 1GD-FTV INTAKE / EXHAUST _0385722 INTERCOOLER G

1GD-FTV INTAKE / EXHAUST  INTERCOOLER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 17940D 1.INSPECT FINS FOR BLOCKAGE

a.

Visually check the intercooler assembly.

i.
A438165C01
1.042,2.969 1.354,3.125 0.313,0.156 10 false *a 2.25,2.948 2.563,3.104 0.313,0.156 10 false *b
*a OK
*b NG


If the intercooler assembly fins are dirty as shown in the illustration, clean them.



b.
A112201

Check that the intercooler assembly is not blocked with leaves, dirt or insects.

If the fins are blocked, wash them with water or a steam cleaner.

NOTICE:
·

If the distance between the steam cleaner and core is too close, the fins may be damaged.

·

When cleaning the intercooler assembly, make sure no water enters its interior.

·

Keep the following injection distance.

Standard Injection Distance:
Injection Pressure Specified Condition
2942 to 4903 kPa
(30 to 50 kgf/cm2, 427 to 711 psi)
300 mm (11.811 in.)
4903 to 7845 kPa
(50 to 80 kgf/cm2, 711 to 1138 psi)
500 mm (19.685 in.)


·

If the fins are bent, straighten them with a screwdriver or pliers.

·

Never apply water directly to the electronic components.



HINT:

Above illustration is an example.



c.

Dry the fins with compressed air.