DESCRIPTION
Blind spot monitor data and Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the GTS to check for malfunctions and to perform repairs.
CHECK DLC3
Check the DLC3.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>GENERAL INFORMATION
DIAGNOSIS FUNCTION
The blind spot monitor system displays an error message on the multi-information display to inform the driver that the system is unavailable either temporarily or due to a malfunction.
When the system is unavailable temporarily:
Multi-information display displays "Blind Spot Monitor Unavailable".
When the system is unavailable due to a malfunction:
Multi-information display displays "Blind Spot Monitor System Malfunction Visit Your Dealer".
The RCTA function displays an error message on the multi-information display to inform the driver that the system is unavailable either temporarily or due to a malfunction.
When the system is unavailable temporarily:
Multi-information display displays "Rear Cross Traffic Alert Unavailable".
When the system is unavailable due to a malfunction:
Multi-information display displays "Rear Cross Traffic Alert Malfunction Visit Your Dealer".
ABNORMALITY HISTORY
The abnormality history for a blind spot monitor sensor can be displayed or cleared.
Check abnormality history
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the blind spot monitor system on.
Turn the GTS on.
Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Utility / BSM Master Abnormal History or BSM Slave Abnormal History.
| Tester Display |
|---|
| BSM Master Abnormal History |
| Tester Display |
|---|
| BSM Slave Abnormal History |
Check the results displayed for the abnormality history check.
If "Yes" is displayed, check the suspected area column for each item.
Abnormality history is stored only for the blind spot monitor sensor for which an abnormality has been detected.
If "No" is displayed, refer to Problem Symptoms Table.
Clearing abnormality history
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Turn the blind spot monitor system on.
Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Utility / BSM Master Abnormal History or BSM Slave Abnormal History.
| Tester Display |
|---|
| BSM Master Abnormal History |
| Tester Display |
|---|
| BSM Slave Abnormal History |
Clear the abnormality history.