Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Front) › 2019.02–2019.06
RM35X0E _56 Audio / Visual / Telematics _079315 PARK ASSIST / MONITORING _0385741 ULTRASONIC SENSOR(for Front) A

PARK ASSIST / MONITORING  ULTRASONIC SENSOR(for Front)  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 89341K 2.REMOVE FRONT CORNER ULTRASONIC SENSOR

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



a.
B540052

Disconnect the connector.


b.
B540053C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the claw and remove the front corner ultrasonic sensor.

NOTICE:

Before removing the sensor, make sure to mark the sensor and front bumper cover so that each sensor can be returned to its original position.



Hide 89347B 3.REMOVE FRONT CORNER ULTRASONIC SENSOR RETAINER

HINT:
·

Perform the following procedure only when replacement of a front corner ultrasonic sensor retainer is necessary.

·

When removing the front corner ultrasonic sensor retainer, if the double-sided tape is difficult to remove, heat the adhesive of the front corner ultrasonic sensor retainer and front bumper cover using a heat light.



a.

Heat the front bumper cover and front corner ultrasonic sensor retainer using a heat light.

CAUTION:
E306500C76
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


·

Do not touch the heat light and heated parts.

·

Touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



Standard:
Item Temperature
Front Bumper Cover 40 to 60°C (104 to 140°F)
Front Corner Ultrasonic Sensor Retainer



b.

Remove the 2 front corner ultrasonic sensor retainers.

B540054