Avoid any impact to the blind spot monitor sensor.
Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.
The blind spot monitor beam axis inspection is performed to confirm whether the sensor is transmitting radio waves.
The blind spot monitor beam axis confirmation is performed to confirm whether the sensor's beam axis is correct, and perform adjustment of the beam axis by using a reflector.
The blind spot monitor sensor installation condition inspection is performed to confirm whether the sensor is placed vertically to the ground (+/-2.2°) by using a jig, and that the sensor is 46 to 54° from the line parallel to the vehicle center line.
88172
1.INSTALL BLIND SPOT MONITOR SENSOR LH
|
Nut |
|
Connector |
Connect the connector.
Install the 3 nuts and blind spot monitor sensor LH.
Do not drop the blind spot monitor sensor LH. If it is dropped, replace it with a new one.
88162
2.INSTALL BLIND SPOT MONITOR SENSOR RH
Use the same procedure described for the LH side.
3.PERFORM BLIND SPOT MONITOR SENSOR INSTALLATION CONDITION INSPECTION
52166A
4.INSTALL REAR BUMPER UPPER COVER LH
52165A
5.INSTALL REAR BUMPER UPPER COVER RH
Use the same procedure described for the LH side.
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER>INSTALLATION
6.INSTALL REAR BUMPER ASSEMBLY
52162B
7.INSTALL REAR BUMPER NO. 1 PLATE
8. PERFORM DIAGNOSTIC SYSTEM CHECK
9.PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SENSOR>ADJUSTMENT