Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR › 2019.02–2019.06
RM35X0E _56 Audio / Visual / Telematics _079315 PARK ASSIST / MONITORING _0385745 BLIND SPOT MONITOR SENSOR A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the blind spot monitor sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement part or procedure Necessary procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Blind spot monitor sensor Blind spot monitor beam axis adjustment Blind spot monitor system (Click here)

PROCEDURE

Hide 52162B 1.REMOVE REAR BUMPER NO. 1 PLATE

Hide 2.REMOVE REAR BUMPER ASSEMBLY

Hide 52166A 3.REMOVE REAR BUMPER UPPER COVER LH

Hide 52165A 4.REMOVE REAR BUMPER UPPER COVER RH

HINT:

Use the same procedure described for the LH side.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER>REMOVAL


Hide 88172 5.REMOVE BLIND SPOT MONITOR SENSOR LH

a.
B525711C01
0,0 0,0 false
V100135

Nut
V100136

Connector


Remove the 3 nuts and blind spot monitor sensor LH.


b.

Disconnect the connector.

NOTICE:

Do not drop the blind spot monitor sensor LH. If it is dropped, replace it with a new one.



Hide 88162 6.REMOVE BLIND SPOT MONITOR SENSOR RH

HINT:

Use the same procedure described for the LH side.