Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING › 2019.02–2019.06
RM35X0E _59 Vehicle Exterior _079322 EXTERIOR PANELS / TRIM _0385757 ROOF DRIP SIDE FINISH MOULDING A

EXTERIOR PANELS / TRIM  ROOF DRIP SIDE FINISH MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 75561A 1.INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP

NOTICE:

When installing new roof drip side finish moulding clip, remove any double-sided tape remaining where the roof drip side finish moulding clip will be installed on the vehicle body and clean the vehicle body with a non-residue solvent.


a.
B435994C01
2.198,0.396 2.51,0.396 false 0.75,0.583 1.594,1.021 true 1.969,0.313 2.281,0.469 0.313,0.156 10 false *a 0.563,0.469 0.875,0.625 0.313,0.156 10 false *b
*a Adhesive
*b 2.0 to 3.0 mm (0.0787 to 0.1181 in.) Bead of Adhesive


Apply a 2.0 to 3.0 mm (0.0787 to 0.118 in.) bead of adhesive (3M DP-105 or equivalent) to each new roof drip side finish moulding clip.

HINT:

Adhesive strength (tensile strength): 13.7 MPa (140.0 kgf/cm2, 1987 psi) or more (when the temperature is 23°C (73°F).)



b.
B525684N01
1.979,1.323 2.135,1.521 0.156,0.198 10 true A 0.781,3.063 0.938,3.26 0.156,0.198 10 true B 1.406,4.469 1.563,4.667 0.156,0.198 10 true B 1.854,3.063 2.01,3.26 0.156,0.198 10 true B 2.469,4.469 2.625,4.667 0.156,0.198 10 true B

Install new roof drip side finish moulding clip to the positions on the roof panel shown in the illustration. Determine the locations and firmly press and install the roof drip side finish moulding clips.

Standard Measurement:
Area Measurement
A 4.3 to 5.3 mm (0.169 to 0.209 in.)
B 3.0 mm (0.118 in.)



c.

Install the roof drip side finish moulding when 40 minutes or more have elapsed since the roof drip side finish moulding clips were installed.

HINT:
·

Initial hardening time: 40 minutes

·

Complete hardening time: 24 hours




Hide 75558F 2.INSTALL ROOF DRIP SIDE FINISH QUARTER MOULDING LH

a.
B525685C01
0,0 0,0 false
V113147

Install in this Direction


Attach the clip and install the roof drip side finish quarter moulding LH.


b.

Remove the protective tape.