69298
1.REMOVE BACK DOOR INSIDE HANDLE COVER (w/ Handle, w/ Cover)
69291
2.REMOVE BACK DOOR INSIDE HANDLE ASSEMBLY (w/ Handle)
69783B
3.REMOVE BACK DOOR INSIDE HANDLE BEZEL (w/ Handle, w/o illumination)
69783B
4.REMOVE BACK DOOR INSIDE HANDLE BEZEL (w/ Handle, w/ illumination)
67961A
5.REMOVE BACK DOOR PULL STRAP
67751
6.REMOVE BACK DOOR TRIM BOARD
67290
7.REMOVE BACK DOOR DAMPER ASSEMBLY (w/ Damper)
76801
8.REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
|
Protective Tape |
Apply protective tape around the back door outside garnish sub-assembly.
Remove the 2 bolts and 5 nuts.
|
Bolt |
|
Nut |
|
Remove in this Direction |
Using moulding remover D, pull toward the rear of the vehicle and detach the clip.
|
Remove in this Direction |
Using moulding remover D, pull toward the rear of the vehicle and detach the clip.
|
Place Hand Here |
|
Remove in this Direction |
Placing your hand in the gap, pull the back door outside garnish sub-assembly and detach the clip as shown in the illustration.